You know I misread your question. I was just reading the FCC Omni VII
manual and it is the Omni VII that has 10 volts for the mic connector power.
Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message -----
From: "Ed" <w3nr@comcast.net>
To: "Carl Moreschi" <n4py@arrl.net>; "Discussion of Ten-Tec Equipment"
<tentec@contesting.com>
Sent: Sunday, November 19, 2006 5:31 PM
Subject: Re: [TenTec] Omni VI Question
> Carl Moreschi wrote:
> > It says 10 volts.
> >
> > Carl Moreschi N4PY
> > 121 Little Bell Drive
> > Bell Mountain
> > Hays, NC 28635
> > ----- Original Message -----
> > From: "Ed" <w3nr@comcast.net>
> > Cc: "TenTec" <TenTec@contesting.com>
> > Sent: Sunday, November 19, 2006 3:56 PM
> > Subject: [TenTec] Omni VI Question
> >
> >
> >> What is the voltage available at the mic connector ??
> >>
> >> Ed W3NR
>
>
> Thanks...73
>
> Ed W3NR
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|