| To: | <tentec@contesting.com> |
|---|---|
| Subject: | [TenTec] 425 plate current drawing 100ma when idle and in Hi voltage only |
| From: | "KN5H" <kn5h@earthlink.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Tue, 28 Nov 2006 12:48:58 -0700 |
| List-post: | <mailto:tentec@contesting.com> |
Hello to all: My 425 amp is acting strangely. I noticed when idle, the plate current meter shows approx 100ma. Then if I switch the amp's voltage from HI to LOW, it normals out. Any ideas? Thanks 73 de KN5H |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [TenTec] FS: Filters 217 and 219 For Omni , Original Orion and Others, Mike Gorniak |
|---|---|
| Next by Date: | [TenTec] Corsair II manual available, k7gt |
| Previous by Thread: | [TenTec] FS: Filters 217 and 219 For Omni , Original Orion and Others, Mike Gorniak |
| Next by Thread: | Re: [TenTec] 425 plate current drawing 100ma when idle and in Hivoltage only, Ron Castro |
| Indexes: | [Date] [Thread] [Top] [All Lists] |