Speaking of my little Argosy -- it's time to rebuild the PTO. It's not
all that flaky, but could use the attention anyway. Besides, i have a
ten Tec PTO rebuild kit on hand, so why not do it?
The first step. of course, is to remove the PTO. How does one do
this? I'd rather learn the procedure from someone who's "been there"
than to tear down the rig more than necessary. I'm guessing the PTO
is held in place by screws behind the front panel since I see no other
obvious anchor points. It also looks as if wires need to be unsoldered
from feed-through terminals and a ground lug on one side of the unit
-- but that's it. Am I correct?
Many thanks and 73,
Craig
W3CRR
|