Keep in mind also that when using a logging program in
conjunction with the Orions if you click on a packet cluster
spot that will be remembered in one of the four registers.
john-n4dsp
----- Original Message -----
From: "John T. Fleming" <W3GQJ@earthlink.net>
To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Sent: Saturday, January 13, 2007 5:19 PM
Subject: Re: [TenTec] auto mode change
> John,
>
> Each band button has 4 settings referred to as stacking registers. On my
> radio, if I start with the "first" register for 20 meters, it is 14.035
> LCW
> 900 Hz bandwidth. The second push is 14.070 USB 3000 Hz. The next is
> 14.167 USB 2350 Hz. The fourth is 14.329 USB 2350 HZ. If I press the
> button again, I will be back to the CW register setting. These settings
> will be there unless I am in one of them and change the setting. Then the
> next time I come back to that register, it will be what ever I was using
> when I left that register or band. I hope this makes sense to you. Look
> at
> stacking registers in the manual.
>
> 73,
> John
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|