| To: | tentec@contesting.com |
|---|---|
| Subject: | Re: [TenTec] Omni VI tracking - C16 |
| From: | "Fraser Robertson" <g4bjm@hotmail.com> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Fri, 19 Jan 2007 13:51:48 +0000 |
| List-post: | <mailto:tentec@contesting.com> |
I just checked the manual. You need to adjust trimmer C16, which is on the corner of the TX Audio Board. That alters the CW TX freq in relation to the RX freq. (Ours was so far off I had to pad it with another C to get it right!). 73 Fraser G4BJM _________________________________________________________________ Find Love This New Year With match.com! http://msnuk.match.com _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Code Speed, Martin AA6E |
|---|---|
| Next by Date: | [TenTec] Thinking about a TT, Martin Sole |
| Previous by Thread: | Re: [TenTec] Omni VI tracking, Fraser Robertson |
| Next by Thread: | Re: [TenTec] Omni VI tracking - C16, Fraser Robertson |
| Indexes: | [Date] [Thread] [Top] [All Lists] |