TenTec
[Top] [All Lists]

[TenTec] Paragon Problem -spurs on either side of carrier

To: tentec@contesting.com
Subject: [TenTec] Paragon Problem -spurs on either side of carrier
From: joel hallas <jrhallas@optonline.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 28 Jan 2007 08:18:20 -0500
List-post: <mailto:tentec@contesting.com>
Folks,

I seem to have a new problem with my Paragon. It transmits spurs 600 Hz above and below the carrier about 10 to 20 dB down from the carrier. This was reported to me by someone using the spectrum scope on an SDR-1000. I have confirmed that at least one is there on another receiver and the level seems about right. I can also notice the effect on strong receive signals. I thought it was them <g>!

I will put it on the spectrum analyzer at work next week, but wondered if this is a known problem? I have done the "routine" things like tighten all board screws and reseat all connectors and master reset.

Any thoughts?

Thanks!

Joel Hallas, W1ZR


<Prev in Thread] Current Thread [Next in Thread>