TenTec
[Top] [All Lists]

Re: [TenTec] Paragon Problem -spurs on either side of carrier

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Paragon Problem -spurs on either side of carrier
From: joel hallas <jrhallas@optonline.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 28 Jan 2007 12:05:39 -0500
List-post: <mailto:tentec@contesting.com>
This happens in Tune or CW. I can't generate a pure enough sinewave to measure in SSB, but will next week. I took some data on receive this morning and the spurs are down at least 40 dB on receive. I don't generally operate FSK.

73, Joel, W1ZR

Mike Hyder -N4NT- wrote:

What mode are you running?  If AFSK, how are you creating the shifts?

73, Mike N4NT

----- Original Message ----- From: "joel hallas" <jrhallas@optonline.net>
To: <tentec@contesting.com>
Sent: Sunday, January 28, 2007 8:18 AM
Subject: [TenTec] Paragon Problem -spurs on either side of carrier


Folks,

I seem to have a new problem with my Paragon. It transmits spurs 600 Hz above and below the carrier about 10 to 20 dB down from the carrier. This was reported to me by someone using the spectrum scope on an SDR-1000. I have confirmed that at least one is there on another receiver and the level seems about right. I can also notice the effect on strong receive signals. I thought it was them <g>!

I will put it on the spectrum analyzer at work next week, but wondered if this is a known problem? I have done the "routine" things like tighten all board screws and reseat all connectors and master reset.

Any thoughts?

Thanks!

Joel Hallas, W1ZR
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec



<Prev in Thread] Current Thread [Next in Thread>