Check the wiring. Once in a while, Heil has been known to get the pins
mixed up. Also check for the usual in the mic and cables: cold solder
joints, broken wires or shields, etc.
Ron N6IE
www.N6IE.com
(Formerly N6AHA)
----- Original Message -----
From: "Gary Strong" <gjstrong@comcast.net>
To: <tentec@contesting.com>
Sent: Sunday, January 28, 2007 9:21 AM
Subject: [TenTec] AM Radio in SSB transmission
I purchased a Heil HM10 for my Orion II. Speaking with Heil, they said the
appropriate cord was a modified Yaesu 8 piin cord, and as such I purchased
it from Heil.
I just hooked it up yesterday and while testing everything on a dummy
load,
I am getting a local AM broadcast station on my microphone audio. While
not
loud, clearly able to be heard. Before I open up the cord, has anyone had
this problem? I understand the mike is grounded through the shell of the
connector, so I did make sure it was tight.
All equipment is grounded and appears to have no other problems.
Obviously
with all the threads on grounding, my setup is the typical ground rod,
short
#6 wire, to a single ground point setup. Any ideas?
Gary
KO0Q
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|