TenTec
[Top] [All Lists]

[TenTec] Omni VII Version of N4PY Software now Available

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: [TenTec] Omni VII Version of N4PY Software now Available
From: "Carl Moreschi" <n4py@arrl.net>
Reply-to: Carl Moreschi <n4py@arrl.net>,Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 1 Apr 2007 21:56:20 -0400
List-post: <mailto:tentec@contesting.com>
My N4PY Pegasus program now supports the new TenTec Omni VII.  My program
supports this radio in 3 different ways.

Front Panel Radio Mode - The program supports the radio in this mode with
limited function from the program.  This is the mode to use if you primarily
want to operate the radio from the radio's front panel and only occationally
will supplement your operation from the program.

Remote mode from a local computer via the serial port - Use this mode if you
want to control the radio 100% from the program via the serial port.  This
mode offers fantatsic control of the radio with full support for the Tentec
302 remote pod.  It even allows for the Omni VII to have an rx320, Pegasus,
Jupiter, or RX340 as a fully functional hands off sub-receiver for DUAL
receive for split DX pileups.

Remote mode from a remote computer via ethernet - This mode is only
partially implemeted at this time.  All functions are fully operating using
a unique guaranteed delivery method via UDP.  The audio to and from the
radio is not yet implemeted in this version.  This support will come in the
next version on May 1.  For now, if you have a computer near the remote Omni
VII, you can use Skype or something similar for the remote audio.

See my webpage at www.n4py.com

Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>