Barry,
You may be right - I'm not sure I loaded the last version due to
some of the problems noted. I found that the input level was significantly
different for PSK levels (I was set on "4" and had to move it to "90"!) I
don't know why these values vary so widely from version to version.
73, Duane
Duane Calvin, AC5AA
Austin, Texas
www.ac5aa.com
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Barry N1EU
Sent: Wednesday, April 25, 2007 9:00 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Orion 2.060b Receive Audio levels down quite a bit
On 4/26/07, Duane Calvin <ac5aa1@gmail.com> wrote:
>
> I don't know if others are noticing this too, but the audio output of the
> Orion's 8-pin DIN rear connector seems to be down quite a bit from the
> last
> version of the FW. On my DigiKeyer, I have to run the level control
> almost
> full out to see the same thing I saw with a 10 o'clock setting on the last
> level.
>
> I notice that audio to the speaker and the headsets are also down - on my
> Heil Pro-Set I have to run the control at about 80% for normal volume.
> Something isn't right on this score.
>
>
Wasn't it about the same with v2.059 (i.e., it was a problem and still is)?
73,
Barry N1EU
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|