I would suspect that something is wrong. If the radio can be controlled by
external rig software with reasonable response, then the firmware download
should be done in 3 minutes or so. Make sure the file didn't get hammered
when you loaded it off the Internet to your computer.
Ron N6IE
www.N6IE.com
----- Original Message -----
From: "M. K. Hess" <mkhess@frontiernet.net>
To: <tentec@contesting.com>
Sent: Thursday, April 26, 2007 2:15 AM
Subject: [TenTec] New OII Firmware
> Folks,
>
> This is the first time I've done a TenTec reflash. How long should it
> take?
> It's been going for 12 hours now, and it's only written 4100 lines of the
> 9700
> that are part of the package. I would suspect that's not normal. I'm using
> a
> USB/Serial
> convert cable on a port set for 56K. It's the same connection I use for
> logging, and
> remote control and it works fine for that purpose. Any hints?
>
> Regards, DE Mike, N3EAQ
> www.n3eaq.net
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|