| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Omni 6 Birdies |
| From: | VE1BN <ve1bn@eastlink.ca> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Fri, 18 May 2007 09:00:14 -0300 |
| List-post: | <mailto:tentec@contesting.com> |
Hi Dave - Am curious. Can you send a pix through for that can soldering on the front end filter board you mentioned? Might clean up the very few weak birdies here, although they are not heard with the antenna on. 73 - Don, ve1bn@eastlink.ca _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] [orion565] 2.061f computer control problem, chip_brown |
|---|---|
| Next by Date: | [TenTec] Omni 6 Birdies, Dennis OConnor |
| Previous by Thread: | [TenTec] Omni 6 Birdies, Dave Bowker |
| Next by Thread: | Re: [TenTec] Omni 6 Birdies, Barry N1EU |
| Indexes: | [Date] [Thread] [Top] [All Lists] |