TenTec
[Top] [All Lists]

Re: [TenTec] When did Ten-tec switch to Schottky diode ring mixers?

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] When did Ten-tec switch to Schottky diode ring mixers?
From: George K3GP <k3gp@arrl.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 20 May 2007 16:11:45 -0400
List-post: <mailto:tentec@contesting.com>
Kevin Purcell wrote:
> Excellent. Thanks Steve for that data point. And Don, NN8B, who  
> replied too. Both have the Corsair 2.
> 
> So they had switched by 1986.
> 
> Anyone with an original Corsair (Corsair 1, so to speak)? I think  
> that might be the rig they made the switch to schottky diodes.
> 
> It would just take a second to check the schematic in the manual on  
> the RF Mixer board :-)
> 

My original corsair manual lists the mixer diodes on the RF mixer board 
(D9 thru D12) as MBD-101  which checks out to be 7v low noise shottky 
diodes.

333-3333
George K3GP

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>