TenTec
[Top] [All Lists]

Re: [TenTec] When did Ten-tec switch to Schottky diode ring mixers?

To: tentec@contesting.com
Subject: Re: [TenTec] When did Ten-tec switch to Schottky diode ring mixers?
From: "Dr. Gerald N. Johnson" <geraldj@storm.weather.net>
Reply-to: geraldj@storm.weather.net,Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 21 May 2007 20:22:11 -0600
List-post: <mailto:tentec@contesting.com>
On Mon, 2007-05-21 at 08:50 -0700, Kevin Purcell wrote:
> Is the behavior the same on the Corsair 1?
> 
> This is an interesting (if odd) result. Especially as it is an  
> important issue for comparing IMD DR and other numbers (which is what  
> I'm doing). Sherwood (et al) will turn off a preamp (fair enough) but  
> they won't turn on an attenuator (fair enough too, because it doesn't  
> affect the IMD DR just moves the useful range up in).
> 
> So when the control is "interestingly" (mis-)labeled like this one  
> then that would "mess up" their standard measurement setup.
> 
> <http://www.w8ji.com/receivers.htm>
> 
> 73 Kevin
> N7WIM

Perhaps I mis-wrote. Its not really an optional preamp but the entire RF
stage that is unhooked connecting the antenna directly to the mixer.
Some might consider that the normal RF stage, not a preamp. On 75
meters, mine is disconnected most of the time. Need the additional
dynamic range on the top end afforded by reducing the RF gain before
that first mixer. I can't find my Corsair II manual this evening to
check on that attenuator detail.

73, Jerry, K0CQ

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>