On Wed, 2007-05-30 at 10:52 -0400, OTAKEBI@aol.com wrote:
> Have a friend who has an OMNI V like mine but his frequency display is off.
> When mine reads say 28.300.00 his will read 28.300.30.
> I also checked on WWV and he is off at 10.000.00 by .30.
> When he transmits you can tell he is off by at least that much.
> As you all know the OMNI V manual has hardly any repair instructions.
> This would seem to be a simple fix but I do not want to try without
> instructions.
> Would anyone on the list have this information, hopefully is done or
> suggested by Ten Tec?
> Thanks in advance,
> Dan/N4VET
>
We ain't channelized (except on 60 meters). So dial it until it sounds
good and ignore the readout so long as you aren't playing footsie with a
band edge.
Its probably either the reference oscillator for the synthesized VFO,
the band crystals or the BFO shifts. Or some of all of those. Setting
all these should be in some alignment instructions but I don't have
them.
73, Jerry, K0CQ
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|