TenTec
[Top] [All Lists]

Re: [TenTec] Frozen display on Omni V.9

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Frozen display on Omni V.9
From: "Mike K9MI" <k9mi@sbcglobal.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 31 Jul 2007 00:14:46 -0000
List-post: <mailto:tentec@contesting.com>
Correct me if I'm wrong, but I've always thought of the V.9 and V.92 as 
firmware, not software. And it sounds like the display problem is hardware.

73, Mike K9MI


----- Original Message ----- 
From: "Rick Denney" <rick@rickdenney.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Monday, July 30, 2007 18:04
Subject: Re: [TenTec] Frozen display on Omni V.9


> Bob McGraw - K4TAX writes...
>
>> Could this be one of those "3rd party" software glitches?
>
> Could be, but not likely. The N4PY software has been in use on Omni
> V's for quite a number of years, and I've found nothing in the various
> archives linking lockup issues to that software.
>
> I have, however, found a few references in the archives linking
> glitches requiring reset to the original software.
>
> I was doing the research leading up to the purchase (two weeks ago) of
> a V.9 rig, which turned out to be Rick Williams's former rig. I have
> too little experience to speak from that, and can only relate what has
> appeared in the archives.
>
> Rick, KR9D
>
> ---
> Richard W. Denney, Jr. PE|Iteris, Inc.              |
> Associate Vice President |107 Carpenter Dr. Ste 230 |    703.925.3819
> rwd@iteris.com           |Sterling, VA 20164        |Fax 703.471.1757
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>