| To: | "Discussion of Ten-Tec Equipment" <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Ooooppppsss...need baud rate too.... |
| From: | "Carl Moreschi" <n4py@arrl.net> |
| Reply-to: | Carl Moreschi <n4py@arrl.net>,Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Tue, 31 Jul 2007 17:17:26 -0400 |
| List-post: | <mailto:tentec@contesting.com> |
It runs at 57,600 baud. Carl Moreschi N4PY 121 Little Bell Drive Bell Mountain Hays, NC 28635 ----- Original Message ----- From: "John" <fraz1@bellsouth.net> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com> Sent: Tuesday, July 31, 2007 5:07 PM Subject: [TenTec] Ooooppppsss...need baud rate too.... > Thanks...........John > _______________________________________________ > TenTec mailing list > TenTec@contesting.com > http://lists.contesting.com/mailman/listinfo/tentec _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Digital "address" for the Orion (1), Carl Moreschi |
|---|---|
| Next by Date: | Re: [TenTec] Low power output on Argonaut V, Stuart Rohre |
| Previous by Thread: | [TenTec] Ooooppppsss...need baud rate too...., John |
| Indexes: | [Date] [Thread] [Top] [All Lists] |