Rick Williams wrote:
Bob if you go to my website (link below) and open the Omni V.9 document
there's a blow by blow set of instructions to remove the keypad. It's in
the 2nd part of the document after the description of the Omni V.9 mod.
73,
Rick
VE7TK
The new digital encoder arrived yesterday from TenTec and I installed it
today. It seems to have done the trick.
The replacement was pretty straightforward, following Rick's lead about
the second part of the Omni V.9 instructions.
The only tricky bit was getting all the sockets back on to the plugs on
the keypad board, especially no 95 which is just below the display.
There's 6 pins on the board and 5 on the connector so, if you're going
to attempt the replacement, make sure you mark which is the spare pin
before you take off the front panel.
Many thanks again for all your help,
73
Bob
MM0RKT
|