Mike,
I'm guessing failed switching diodes. I had the same problem with mine.
(If I hadn't given away the manual I could tell you the board, but after I
traded it in on an O-II I gave away the manual.)
A trip to Ten Tec may be the best choice.
Bernie
In a message dated 10/13/2007 10:52:54 P.M. Central Daylight Time,
wq5c@texas.net writes:
Hi all,
My Omni VI has developed a problem. Does anyone recognize these symptoms?
1) RX seems fine
2) any TX immediately trips off the power supply ( model 961 )
3) power cycling the PS restores everything
4) occurs with minimum power out
5) the power supply is OK - it drives another rig to 100W without tripping
Any thoughts or suggestions before it gets sent back to TT?
Thanks!
--Mike, WQ5C
************************************** See what's new at http://www.aol.com
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|