Hi Darrell,
It happens going into a dummy load as well as a real antenna.
Thanks!
--Mike WQ5C
At 12:32 PM 10/14/2007, you wrote:
>Are you working into a good antenna match? I have this problem too when my
>238 can't couple my carolina windom on 30 meters. The power that it trips
>at depends on how bad the mismatch is. Into a dummy load everything is
>fine. DE W4CX
>
>-----Original Message-----
>From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
>On Behalf Of Michael Pfeuffer
>Sent: Saturday, October 13, 2007 11:52 PM
>To: tentec@contesting.com
>Subject: [TenTec] Omni VI troubleshooting ( TX trips PS breaker )
>
>
>Hi all,
>
>My Omni VI has developed a problem. Does anyone recognize these symptoms?
>
>1) RX seems fine
>2) any TX immediately trips off the power supply ( model 961 )
>3) power cycling the PS restores everything
>4) occurs with minimum power out
>5) the power supply is OK - it drives another rig to 100W without tripping
>
>Any thoughts or suggestions before it gets sent back to TT?
>
>Thanks!
>--Mike, WQ5C
>
>
>
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec
>
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|