TenTec
[Top] [All Lists]

Re: [TenTec] What is the best Ten Tec Tuner

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>,"'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Subject: Re: [TenTec] What is the best Ten Tec Tuner
From: jones_winston@bellsouth.net
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 08 Nov 2007 15:08:30 +0000
List-post: <mailto:tentec@contesting.com>
While it's not a Ten-Tec brand, I use an LDG automatic tuner with my Jupiter. 
It helps match up any slight mismatches on my Butternut vertical, especially on 
the wider bands. I think LDG once made the auto tuners that go in the newer 
Ten-Tec rigs. Several other companies, such as MFJ, make similar products. The 
LDG is in the low $100s range. I believe Ten-Tec's only auto tuner is for 
larger power and much more expensive.

73, Winston K4CWQ



-------------- Original message ----------------------
From: <gsanderlin@charter.net>
>
> Looking for a Ten Tec tuner to match Omni VI plus.
> 
> Which one is recommended?  I don't currently run an amplifier. I use a
> Carolina Windom antenna, so I do need a tuner and like building wire
> antennas.
> 
> Thanks
> 
> -----Original Message-----
> From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
> On Behalf Of Rick Denney
> Sent: Wednesday, November 07, 2007 12:07 AM
> To: Discussion of Ten-Tec Equipment
> Subject: Re: [TenTec] Omni VI and non TT Amp
> 
> Ken Brown writes...
> 
> > Last time I had an amplifier using anything like 811A tubes, they
> > were actually 572B, and it took two of them to get 650 to 800 watts
> > out. It was a Heath SB-200. Is that really an 811A?
> 
> I was talking about the Ameritron AL-811a amplifier, which uses three
> 811a transmitting tubes, not the tube itself. The 572b tubes are
> indeed capable of greater output because of their higher plate
> dissipation rating, their greater grid current rating, and their
> higher plate voltage. Yes, the 572b is "like" an 811a tube, and some
> use them in amps designed for 811a tubes because of their perceived
> greater durability, but they aren't really the same.
> 
> Rick, KR9D
> 
> ---
> Richard W. Denney, Jr. PE|Iteris, Inc.
> Associate Vice President |107 Carpenter Dr. Ste 230 |    703.925.3819
> rwd@iteris.com           |Sterling, VA 20164        |Fax 703.471.1757
> 
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>