I recently purchased (for $5) a headset designed for computer use. It's
the "closed" design, so while to me it eventually becomes uncomfortable,
before that it makes listening easier by reducing external noise.
The microphone, is a low voltage condenser unit that requires DC.
A computer sound card puts out five volts, but I think that much
less will do.
I would like to use this on a Triton IV (D) (model 544), which does not
provide DC. I'm looking for a circuit that would allow me, with a minimum
of parts (parts are hard to find here), to use it.
I expect that I could use a three volt lithium cell and a current
limiting resistor to provide the DC, and then use a capacitor
to block the DC on the input of the radio. I would then have
to use VOX, or an external transmit switch.
Any suggestions?
Thanks in advance,
Geoff.
--
Geoffrey S. Mendelson, Jerusalem, Israel gsm@mendelson.com N3OWJ/4X1GM
IL Voice: (07)-7424-1667 U.S. Voice: 1-215-821-1838
Visit my 'blog at http://geoffstechno.livejournal.com/
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|