TenTec
[Top] [All Lists]

Re: [TenTec] OMNI6 PLUS Alignment procedure needed

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] OMNI6 PLUS Alignment procedure needed
From: "Lew " <ljl160@verizon.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 28 Dec 2007 19:57:23 -0500 (Eastern Standard Time)
List-post: <mailto:tentec@contesting.com>
Thanks Rob! I am very careful when aligning anything from previous" not so
good experiences". I learned to mark or make note of where an adjust started
from -hi! Hopefully, the actual Ten Tec alignment data  not in the manual
has the correct info. 73 Lew K1NDV
 
-------Original Message-------
 
From: Rob Atkinson
Date: 12/28/07 18:57:36
To: tentec@contesting.com
Subject: Re: [TenTec] OMNI6 PLUS Alignment procedure needed
 
Warning:  In the Omni 6 manual, there are a couple of errors in the
designators for some trimmer caps that adjust things like the carrier set
point and the cw tx frequency (so it is on the display frequency).  I do not
recall the details but I think there are earllier messages in the reflector
archive that correct these errors in the manual.  Search them out before you
try to allign the rig.  I did not know the manual had errors until after
trying to do an allignment on mine and the result is that I got a few things
out of adjustment.  I was lucky in that I didn't mess up any of the cw
adjustments and I use the Omni 6 for cw.
 
73
 
rob / k5uj
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>