TenTec
[Top] [All Lists]

[TenTec] voice peaks low with shure 444d mic with paragon

To: <tentec@contesting.com>
Subject: [TenTec] voice peaks low with shure 444d mic with paragon
From: john ferro <foxbat426@hotmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 18 Jan 2008 18:00:13 -0500
List-post: <mailto:tentec@contesting.com>
for everyone who responded thank you so much! that symbol does indicate the 
gheil chip - i have version 61. the delay was caused by the mic being wired 
wrong. i also called ten tec today and they confirmed the symbol being that of 
the gheil chip. 

now i have another question - my voice peaks on the paragon are somewhat low - 
even with the processor on. i am using a shure 444d mic. when i tune up the 
paragon with the tune button, which bypasses the mic i am easily getting 120 
watts+ out. i am confused though because with the same mic used with my paragon 
II, my voice peaks were very high and it wasn't a problem. 

ten tec says its the mic and i need to order a ten tec desk or hand mic for 
best results. when i asked him why the shure 444d mic worked well with the 
paragon II he said that there were about 6 versions of audio boards (different 
resistor values on each board) that went into the paragons and some worked 
better with the shure 444d than others, based on when they were released and 
what board my paragon has - 

has anyone else had problems with the 444d and the paragon or other ten tec 
rigs for that matter. does this explanation sound correct.

thx again, john
_________________________________________________________________
Shed those extra pounds with MSN and The Biggest Loser!!
http://biggestloser.msn.com/
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>