Sounds like the caps in the 5V regulator need to be replaced.
73
Bob, K4TAX
----- Original Message -----
From: "Cedric Baechler" <cedric@baechler.cx>
To: <tentec@contesting.com>
Sent: Tuesday, February 05, 2008 3:20 AM
Subject: [TenTec] Problem (reboot) with my Orion II when I switch it on
Hello,
I have the following problem with my Orion II:
When I start it by using the switch on/off button the Ten-Tec logo
appears, then the normal screen (with frequency, sweep, ..) for a few
seconds then it reboots itself. This can happen 5-6 times until the
normal screen stays and the Orion is ready to use. Sometime during the
boot process and when the normal screen appears I see a single
horizontal white line on the screen!!
Before I contact Ten-Tec, has someone had this problem previously and
can help me?
73, Cedric HB9HFN
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|