TenTec
[Top] [All Lists]

Re: [TenTec] OMNI V Computer Hookup?

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] OMNI V Computer Hookup?
From: John Huffman <hjohnc@gmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 18 Feb 2008 11:20:41 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
The OMNI V had very little software to support it's computer command 
set.  I never even found a logger to work with it.

However, if you get the Omni V.9 chip from N4PY it will emulate an Icom 
and work with most, if not all, programs.  You get the 'get' and 'set' 
commands for frequency and mode, which are all you need for most logging 
and contest software.

It's not a radio that lends itself to full computer control.  Too few 
commands over a slow interface.

73 de K1ESE
John

OTAKEBI@aol.com wrote:
> I have an OMNI V that I would like to hookup to a computer.
> However,I do not know if it is worth the effort.
> The manual does not go into any detail as to features available with the  
> computer hookup.
> The manual just shows cable hookup and refers you to software program for  
> features.
> Did TT provide a software program with the radio?
> What can be done via the computer?
> What programs are available as to software?
> Thanks in advance,
> Dan/N4VET
> 
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>