I'd say as good today as it was 10 years ago. Now as to the electrolytic
caps........ they are another story. Likely they will need immediate
replacement. Also the fan will need cleaning and a lube job. If you so
choose to power it up, do so with a Variac at about 10 volts per minute
until you reach line voltage. Listen for any unusual noise and watch for
smoke. Should, at any point, you observe a large and loud explosion, first
obtain laundry service for your trousers, and then prepare to clean the
inside of the power supply area and then replace all the electrolytics.
73
Bob, K4TAX
----- Original Message -----
From: "DC" <[email protected]>
To: "Discussion of Ten-Tec Equipment" <[email protected]>
Sent: Monday, February 18, 2008 9:10 PM
Subject: [TenTec] Titan 425 shelved for 10 years
How good is the final tube in a Titan 425 thats been un-used for ten
years?
thank you
73
[email protected]
_______________________________________________
TenTec mailing list
[email protected]
http://lists.contesting.com/mailman/listinfo/tentec
|