Rick,
I have been operating my Jupiter directly from my soundcard into the
line input and output. I am now running as suggested. That is I have
set the power output to 100 watts. Then I reduce the soundcard levels so
that the ALC light just goes out and does not flicker. Depending on
band, and maybe SWR, it yields 30-50 Watts output. I have been
receiving reports on my clean signal with this setup.
My output from the Jupiter is moderated by the soundcard as well. I
reduce the input level until I see a nice clean signal on the waterfall
display.
I also operate RTTY with the same settings and that seems to work very
well also.
Regards,
John Graves
WA1JG
jh.graves@verizon.net
Henry Mackey wrote:
Rick,
No. I have heard, but not knowing, that this is not a good idea. So to appease
myself I purchased from Donner Digital an interface, plugged it in and away I
went. Well wasn't quite that easy, but that is what I've been using since about
January of 04.
73 de Henry/n9hm
----- Original Message -----
From: wo8l@aol.com
To: tentec@contesting.com
Sent: Sunday, February 17, 2008 4:47:58 PM (GMT-0500) America/New_York
Subject: [TenTec] Ten Tec Jupiter on PSK31
Anybody using the Jupiter on PSK with just the Ten Tec supplied chord directly
to the computer sound card with no TNC?
Does this really work?? What settings on the rig are appropriate?
Thanks,
Rick
WO8L
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|