Re: [TenTec] Ten Tec 238A settings?

["Bob McGraw - K4TAX" <RMcGraw@Blomand.net>]

I've not been successful in getting the 238 tuner to work on 6 meters. 
Maybe just my antenna combinations but can't get a 1:1 match with a 50 ohm 
load on the output either.  So I figure the stray inductance and capacitance 
inside is just too much.  Not surprised however.
73
Bob, K4TAX


----- Original Message ----- 
From: "Dr. Gerald N. Johnson" <geraldj@storm.weather.net>
To: <tentec@contesting.com>
Sent: Friday, April 11, 2008 6:38 PM
Subject: Re: [TenTec] Ten Tec 238A settings?


> On Fri, 2008-04-11 at 16:11 -0700, Denton wrote:
> > Dug out my trusty link coupled transmatch that is made exclusively for 
> > twin
> > lead and pressed it into service. Have found another tap that give me 
> > less
> > sharp tuning range for 75 and 80 meters....now to find something for 6
> > meters.
> > Will probably take the ten tec 238a and a couple of LDG auto tuners to 
> > the
> > Yakima hamfest in the morning and see if can do some horse trading.
> I've built a couple 6m tuners. Usually about 4 or 6 turns of #12 1"
> diameter with a little gap in the middle for an adjustable link. Tuned
> by a split capacitor probably 35 pf each section, either dual or
> butterfly capacitor. Two turn link of insulated 12 gauge wire. Move it
> in and out or fix the link and put in a 50 pf variable series capacitor
> on the link ground side. Tap the antenna balanced feed line a couple
> turn out from the center link gap. I used one of those to tune an 80
> double extended Zepp for years. Worked great in the directions it worked
> good, lousy between the many lobes.
>
> 73, Jerry, K0CQ
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec