| To: | "Discussion of Ten-Tec Equipment" <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Omni 6 Plus Repairs |
| From: | "Stuart Rohre" <rohre@arlut.utexas.edu> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Thu, 17 Apr 2008 20:28:54 -0500 |
| List-post: | <mailto:tentec@contesting.com> |
The finals and drive might have been open circuit. If the finals were left
connected to an antenna and nearby lightning got into the rig, anything
could have happened. It is prudent if the Finals went open circuit to
replace the driver as well.
My experience with Ten Tec is that they repair at the lowest cost to the ham consistent with bringing the rig to its full spec. -StuartK5KVH |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Ten-Tec Transceiver Survey, Dr. Gerald N. Johnson |
|---|---|
| Next by Date: | Re: [TenTec] Ten-Tec Transceiver Survey, Stuart Rohre |
| Previous by Thread: | [TenTec] Omni 6 Plus Repairs, Speer, Doug |
| Next by Thread: | Re: [TenTec] Omni 6 Plus Repairs, Gary Tuck |
| Indexes: | [Date] [Thread] [Top] [All Lists] |