Its a small allen wrench, as I recall, to loosen the knobs. If you
have a bunch, just stick them in there and you'll find the right size.
The dialstring can be a bit interesting, I'd take a nice clear photo of
it before disassembly after you pull the face. Its not hard but takes
time and care to get just right.
Clark
WA3JPG
On Apr 22, 2008, at 5:14 AM, Bill Ames wrote:
I have finally located some of the "green" non toxic cleaning stuff
(thank
you to all who pointed me in this direction) and obtained some cotton
balls.
Next is the removal of the knobs. I do not have a manual for this rig
but I
am sure that there is some important information I should know before I
attempt this next step. I would like to know what type/size tool I
will need
to properly access the knob set screws; I don't want to strip them. I
should
probably take the cover off and see if anything is living in there :-(
but I
don't think so. Any suggestions are appreciated.
|