| To: | tentec@contesting.com |
|---|---|
| Subject: | Re: [TenTec] Argonaut 509 |
| From: | "Dr. Gerald N. Johnson" <geraldj@storm.weather.net> |
| Reply-to: | geraldj@storm.weather.net, Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Tue, 22 Apr 2008 11:31:53 -0600 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
On Tue, 2008-04-22 at 13:00 -0400, Mike Hyder -N4NT- wrote: > It seems the big knob uses a smaller allen wrench than the smaller knobs. > The dial skirt can be tricky to reinstall on the shaft. I make a loop of > dental floss and use it to take the tension off the D-spring, it's easily > removed after the skirt is in place. That's described in the Corsair II manual. And it does work. > <SNIP> 73, Jerry, K0CQ _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Argonaut 509, Mike Hyder -N4NT- |
|---|---|
| Next by Date: | [TenTec] Production dates, Antonio Pilichi \(i5 NQK\) |
| Previous by Thread: | Re: [TenTec] Argonaut 509, Mike Hyder -N4NT- |
| Next by Thread: | Re: [TenTec] Argonaut 509, Steve Berg |
| Indexes: | [Date] [Thread] [Top] [All Lists] |