Re: [TenTec] Multifunction Controls on my 6&2

[Paul <designer@quickdata.com>]

I was introduced to "multifunction with an SC-2020. I used MS Word to 
format a small sheet (more 5 x 6 than 3 x 5) that I could fold for 
"two sided" workspace. I put the menu/button combinations on it and 
laminated it. I left enough extra laminate so I could put a hole in 
it with a standard paper punch. I run a cord/string though the hole 
and can attach it to the power cord on the SC-2020 so it is always 
available.  Maybe something like that would work for the 6 N 2. But I 
completely understand that not everyone has a small "home" laminator. 
Perhaps a copy service like Kinkos can do that for you.
73,
Paul