[Top] [All Lists]

[TenTec] PBT and hi low cut

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: [TenTec] PBT and hi low cut
From: "John" <brazos@rochester.rr.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 16 May 2008 17:33:34 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Hello I was on the air today with my Orion II and I was getting some 
interference from a nearby station I tighten up the band pass filter and 
started playing with the PBT and hi - lo cut .  I realized that I still don't 
understand the operation of these controls to move the offending stations or 
move away from this station.  I fiddled with these controls and was unable to 
remove the offending station the controls seemed to do very little if anything 
. Is there a good explanation of how to use these controls some where .  One 
question , do I have to have the pbt light on before I attempt to use the H or 
L cut feature  ?  Thanks  John kb2huk

I am using the free version of SPAMfighter for private users.
It has removed 1889 spam emails to date.
Paying users do not have this message in their emails.
Get the free SPAMfighter here: http://www.spamfighter.com/len
TenTec mailing list

<Prev in Thread] Current Thread [Next in Thread>