TenTec
[Top] [All Lists]

Re: [TenTec] Orion II A9 Board Failure...Again!

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Orion II A9 Board Failure...Again!
From: Alan Sewell N5NA <alan.n5na@gmail.com>
Reply-to: alan.n5na@gmail.com, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Wed, 25 Jun 2008 10:27:07 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
For Firefox users like myself, you'll need to use Internet Explorer to 
view Ron's web page on this fix.  Firefox does not support the .mht format.

73,

Alan  N5NA

http://www.tentecwiki.org



Ron Castro wrote:
> About 10 months ago, the capacitors on the A9 Power Distribution board 
> failed, and I sent the radio back to the factory to get it fixed.  Well, just 
> 10 months later, the same thing happened again.  This time, I decided to fix 
> it myself with premium capacitors purchased through Mouser.  The fix worked!  
> The 470 uf, 16 Volt, 85 degree C caps, C6, C7 and C9 were replaced with 
> ultra-low ESR 50 Volt, 105 degree C units that fit perfectly in the board.  
>
> I have a whole page on my website for anyone interested, including pictures 
> and ordering information for the caps.  Hopefully, these will last longer 
> than the first two sets!
>
> http://n6ie.com/A9_Board.mht
>
>          Ron   N6IE
>       www.N6IE.com
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>   
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>