Have you tried switching the load to ANT 2 ? Is the power supply current
changing as you raise the power ????
Hank K7HP
----- Original Message -----
From: "Tõnno Vähk" <Tonno.Vahk@gildbankers.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Wednesday, July 30, 2008 11:43 PM
Subject: Re: [TenTec] ORION II TX gone
yes, thanks. Keying loops are off and transmitter is ON. I do have the rig
going into TX and showing also 1.0 SWR all the time! Also the pot
indicator shows power but the meter does not and also nothing is going out
by external wattmeter. It shows 1.0 SWR also to empty antenna port. Thus
switching from ANT 1 to ANT 2 does not help.
I will try the recommended battery reset and will also check if the PS
current goes up at TX (I am quite sure it does not...).
I wonder how those guys solved it who have had this issue before?
73
es5tv
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Barry N1EU
Sent: Thursday, July 31, 2008 12:20 AM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] ORION II TX gone
Do you have the keying loops turned off and the Transmitter turned on
in the TX Menu?
73,
Barry N1EU
On Wed, Jul 30, 2008 at 8:06 PM, Tõnno Vähk <Tonno.Vahk@gildbankers.com>
wrote:
Hi, I have lost any TX output from OII. Pwer can be turned up to 100w but
no TX out in any mode, everything else seems normal. RX seems to be OK. I
saw some messages in archives looking for solution to the same issue but
no cure. Tried Master reset and also reinstalled firmware, no change. Is
there anything I can try or should I send it to repairs?? Has it been
established what the problem is?
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|