| To: | "Discussion of Ten-Tec Equipment" <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Paragon II Display problem HELP |
| From: | "Stuart Rohre" <rohre@arlut.utexas.edu> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Thu, 21 Aug 2008 16:15:21 -0500 |
| List-post: | <mailto:tentec@contesting.com> |
Alan,You might check to see if a wire got pinched and a high impedance short was created in the reassembly. I had one wire like that and the insulation was not completely gone, but it was pinched by a metal bracket and gave strange results. (But not a Ten Tec). StuartK5KVH |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Conversations with Ten Tec Engineer(s), Carl J. Denbow |
|---|---|
| Next by Date: | Re: [TenTec] Paragon II Display problem---THANKS, ARDUJENSKI |
| Previous by Thread: | Re: [TenTec] Paragon II Display problem HELP, gsanderlin |
| Next by Thread: | Re: [TenTec] Paragon II Display problem HELP, Scott Prather |
| Indexes: | [Date] [Thread] [Top] [All Lists] |