Re: [TenTec] Advice on removing front panel from Scout

[Stuart Rohre <rohre@arlut.utexas.edu>]

Dave,
I have not done this but remember it is pretty tight around that front 
panel area.  You might at best, be able to swing the front panel 
"hinged" on the interconnecting cables.  Be careful of any board mounted 
pots that might also be bolted by nuts to the front panel and soldered 
to the mother board.  Another model had that, and you could break a pot 
off the board if you were trying to pull the panel without unbolting the 
pot from the panel.
Good luck, most things are accessed without removing the front panel, so 
you might see if you can access from another way.
73,
Stuart Rohre
K5KVH