Hello Bill:
Look at the remote speaker jack. It probably needs replacing. They get bent
w/ age and/or break inside. I've replaced several of them. The tongue in the
jack looses it's tension and arcs and/or doesn't make good contact when
closed.
Best regards,
Ralph Howes
W8BVH
----- Original Message -----
From: "Bill Acito W1PA" <w1pa@hotmail.com>
To: <tentec@contesting.com>
Sent: Friday, October 03, 2008 12:45 PM
Subject: [TenTec] Replacing the speaker in a Delta II/Argonaut II
I have a Delta II that I am refurbing, and it appears that the internal
speaker has
some sort of issue or short. After a few minutes the audio gets very
distorted, and
the audio amp module gets very hot. An external speaker plugged into the
external
jack works fine, and the module stays cool.
In looking at the how the rig's aluminum frame is put together, it looks
like I have to
completely disassemble the radio to get access to the screws that hold the
internal
speak in place.
Has anyone ever done this replacement, and if so, is there an easier way?
Bill
W1PA
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|