OT - Offset tuning - yes, when the Offset Select switch is activated, the OT
LED comes on..... had an OMNI D for about 10 years but sold it and replaced
it with a Corsair II.
Best regards,
CSM(r) Gary Huber - AB9M
9679 Heron Bay Rd
Bloomington, IL 61705
(309-662-0604)
www.csm-gh.com
glhuber@msn.com
gary.huber@us.army.mil
--------------------------------------------------
From: "CSM(r) Gary Huber" <glhuber@msn.com>
Sent: Sunday, January 04, 2009 12:08 PM
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Omni D controls?
SB-N is "normal" for the band selected (LSB for 160, 80, and 40 ; USB for
20, 15, and 10) SB-R is "reverse"
Don't remember the context of "OT" unless it was an LED showing "ALC"
limits.
Best regards,
CSM(r) Gary Huber - AB9M
9679 Heron Bay Rd
Bloomington, IL 61705
(309-662-0604)
www.csm-gh.com
glhuber@msn.com
gary.huber@us.army.mil
--------------------------------------------------
From: "Edouard Bruchac" <edn4zum@windstream.net>
Sent: Saturday, January 03, 2009 9:06 PM
To: <tentec@contesting.com>
Subject: [TenTec] Omni D controls?
Hello,
I picked up a very clean Omni D at a swapmeet in Northern
Alabama,Saturday.
Most of the controls are intuitive,except for the mode selection switch.
Is,"SB-Normal"=USB?
And is,"OT", tied in to the BFO?
Beautiful rig with very nice audio.
73,Ed N4ZUM
Springville,AL
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|