SB-Normal means the correct sideband for the band. For 1.8 to 7 mhz, this
means LSB. For 10 to 30 mhz, this means USB.
SB-Reversed gets the opposite side band.
And OT means offset tune and is used primarily for RIT.
Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message -----
From: "Edouard Bruchac" <edn4zum@windstream.net>
To: <tentec@contesting.com>
Sent: Saturday, January 03, 2009 10:06 PM
Subject: [TenTec] Omni D controls?
Hello,
I picked up a very clean Omni D at a swapmeet in Northern
Alabama,Saturday.
Most of the controls are intuitive,except for the mode selection switch.
Is,"SB-Normal"=USB?
And is,"OT", tied in to the BFO?
Beautiful rig with very nice audio.
73,Ed N4ZUM
Springville,AL
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|