TenTec
[Top] [All Lists]

Re: [TenTec] Ten Tec OII - SSB Distortion

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Ten Tec OII - SSB Distortion
From: "Ron Castro" <ronc@sonic.net>
Reply-to: Ron Castro <ronc@sonic.net>, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 13 Jan 2009 17:08:41 -0800
List-post: <mailto:tentec@contesting.com>
Keith: I just fired up my OII on 160 m AM and did not get the problem you described, so it sounds like something else is going on there. I agree with one of the other posters that you should run AM on 160 into a dummy load and see if that triggers the problem. If not, then RF is a good place to start. If it's not RF, perhaps you should reload the firmware from your computer.

Please note that you will always hear some distortion in the monitor on AM, but this does not come out on the air. Tests I have made with a Perseus SDR receiver indicate that AM in the OII nothing short of excellent with audio response > 5 kHz and no audible distortion. Levels adjust automatically so there is no splatter over a very wide range of input levels.

        Ron N6IE
     www.N6IE.com



----- Original Message ----- From: <ac9s@mchsi.com>
To: <tentec@contesting.com>
Sent: Tuesday, January 13, 2009 12:56 PM
Subject: [TenTec] Ten Tec OII - SSB Distortion


As originally reported, I have been experiencing really distorted SSB with my OII for the last 3 - 4 weeks - after receiving glowing reports for the last 2 years. I have partially 'cured it', but don't have the root cause nailed yet. A master reset will restore the radio to its excellent state, but it appears my problem reappears after checking into a 160 meter AM net we have locally on Sunday mornings. 160 Meter AM operation is always distorted and once I have operated 160 I then have the problem on all other bands with SSB. A master reset now gets me back in operation, but I don't know what is triggering the problem. This Sunday I used my 756Pro and received excellent audio reports on the net. I switched to the Orion and had the distorted report. Asked the guys to switch mode, did a master reset and had excellent audio reports on SSB, which I then validated on 40 and 20.. So - it looks like AM operation on 160. Maybe There is enough RF floating around the shack
on 160 o scramble its little brain, but I have always thought the Pro more succeptable to RF than the O2 and I don't have any evidence of RF in the shack.

Does this trigger any thoughts? I can work around the problem, but clearly something is wrong.

Thanks --

Keith
AC9S
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec



<Prev in Thread] Current Thread [Next in Thread>