I've not noticed any such phenomenon on my VI. Dave,K3TX
----- Original Message -----
From: "Bruce Warner" <kansas4000@hotmail.com>
To: <tentec@contesting.com>
Sent: Tuesday, January 27, 2009 12:58 PM
Subject: [TenTec] Omni VI - AGC and RF Gain Question
Hi - I purchased an Omni VI through this list recently, and just have a
general question. When I have the RF gain fully clockwise then engage the
AGC either in slow or fast, it distorts the speaker, but when I pull back on
the RF gain a few notches (say to the 3 o'clock position) then the AGC no
longer distorts and it picks up the signal while reducing the background
noise. I don't have a copy of the manual, so is this the normal setting to
back off the RF gain when using the AGC (or do I have a problem with my
rig)? Thanks.
_________________________________________________________________
Windows Live™: E-mail. Chat. Share. Get more ways to connect.
http://windowslive.com/howitworks?ocid=TXT_TAGLM_WL_t2_allup_howitworks_012009
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|