I have tried them all, and like you, I have an opinion:
Best all around is Cinch Jones, comes in three sizes, multiple pins from two to
over 24,
very strong with strain clamp and vy easy to solder to and unsolder, socket has
wiping
action upon plug in and out, Medium and large sizes Will take #14 wire if
careful and smaller is a snap!
Comes in panel mount and in-line style, and rare ones
are panel mound males with the pins recessed to avoid damage. Newer ones
have a plastic cap but metal caps are found. Best source: Skycraft in Orlando.
Worse is the PowerPoles.... easy break, hard to solder and unsolder, can easily
separate from partner in two-pin configuration, falls out of socket at a breath
on
it, a really weird plug.
Molex is ok, banana pins ok, binding posts ok, screw terminal strips ok but
will rust.
Sad to see is the JA induced practice of using male sockets which have power on
the exposed pins, like 8pin mic connectors. The rule is ...female for power
source, and
male for obtaining the power but otherwise cold. And remember
NEVER SADDLE A DEAD HORSE......
GL,
Charles Harpole
k4vud@hotmail.com
> From: dxhawg@windstream.net
> To: tentec@contesting.com
> Date: Mon, 26 Jan 2009 19:01:48 -0500
> Subject: [TenTec] 544 power connector
>
> Does anyone know the brand and stock number of the plastic power connector
> that attaches to the rear of the later Ten Tec Triton IV (544)?
>
> Does anyone know the brand and stock number of the metal power connector
> that attaches to the rear of the earlier Ten Tec Triton IV (544)? Jones
> connector?
>
> Thanks/73
> Tom K4RV
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|