19.2 works IF there isn't a flow control issue.
--------------------------------------------------
From: "Ed" <w3nr@comcast.net>
Sent: Saturday, January 31, 2009 8:03 AM
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Ham Radio Deluxe
> CSM(r) Gary Huber wrote:
>> Note; if you choose to use only DB-9 pins 2,3, and 5 for signal, you must
>> use 9600 baud and below speeds with software flow (XON - XOFF) flow
>> control.
>>
>
>
> Thats strange, I only use 2-3-5 and 19200 and all works perfectly. I
> must have missed the above somewhere.
>
> Ed W3NR
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|