i tried Vista for about a month unsuccessfully. i could not find a way to
make my Orion and Vista co-exist. i wiped Vista off my drive and installed
XP. no radio problems since.
jack ak7o
----- Original Message -----
From: <kc9cdt@aol.com>
To: <tentec@contesting.com>
Sent: Friday, 27 February, 2009 5:48 PM
Subject: Re: [TenTec] 041 firmware rev
> What OS are you using...I use XP.
> VISTA IS NOT WELCOME HERE for lots of reasons. Serial support being one.
> 73,
> Lee
>
>
> -----Original Message-----
> From: Jim M. <jmiller1706@cfl.rr.com>
> To: 'Discussion of Ten-Tec Equipment' <tentec@contesting.com>
> Sent: Fri, 27 Feb 2009 6:33 pm
> Subject: Re: [TenTec] 041 firmware rev
>
>
>
> Should take 5 minutes. I had to get a USB to Serial adaptor to get it to
> work rather than use the serial card in the PC. I don't know why.
>
> -----Original Message-----
> From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
> On Behalf Of John
> Sent: Friday, February 27, 2009 6:22 PM
> To: Discussion of Ten-Tec Equipment
> Subject: Re: [TenTec] 041 firmware rev
>
> I have been updating now for over an hour and have only got to line 1050
out
>
> of 10,000 lines should I be patient or just scrap the attempt ?
> ----- Original Message -----
> From: "John" <brazos@rochester.rr.com>
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Sent: Friday, February 27, 2009 6:11 PM
> Subject: Re: [TenTec] 041 firmware rev
>
>
> > When downloading the new firm ware should the radios screen show a
counter
> > of the lines being downloaded ( am in Flash Update Mode ) my radio does
> > not
> > show any running totals John
> > ----- Original Message -----
> > From: "Jim M." <jmiller1706@cfl.rr.com>
> > To: "'Ron Castro'" <ronc@sonic.net>; "'Discussion of Ten-Tec Equipment'"
> > <tentec@contesting.com>
> > Sent: Friday, February 27, 2009 5:37 PM
> > Subject: Re: [TenTec] 041 firmware rev
> >
> >
> >> Well I downloaded it off the web a few times and apparently got a copy
> >> that
> >> works ok now. I wonder if TT puts some sort of checksum or other
> >> integrity
> >> check on the file? If you are getting some weird behavior you might
try
> >> another download off the web until something changes.
> >>
> >> -----Original Message-----
> >> From: tentec-bounces@contesting.com
> >> [mailto:tentec-bounces@contesting.com]
> >> On Behalf Of Ron Castro
> >> Sent: Friday, February 27, 2009 4:49 PM
> >> To: Discussion of Ten-Tec Equipment
> >> Subject: Re: [TenTec] 041 firmware rev
> >>
> >> http://radio.tentec.com/downloads/transceivers/566
> >>
> >> Ron N6IE
> >> www.N6IE.com
> >>
> >> ----- Original Message -----
> >> From: "Jim M." <jmiller1706@cfl.rr.com>
> >> To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
> >> Sent: Friday, February 27, 2009 1:41 PM
> >> Subj
> ect: Re: [TenTec] 041 firmware rev
> >>
> >>
> >>> On the phone with TT, he suggested various reset sequences but the
load
> >>> won't work. Said file might have been corrupted and to download it
> >>> again,
> >>> still no luck. Now reverting back to previous version, hope I didn't
> >>> crash
> >>> my radio. Could someone give me that download site again just to be
> >>> sure?
> >>>
> >>> -----Original Message-----
> >>> From: tentec-bounces@contesting.com
> >>> [mailto:tentec-bounces@contesting.com]
> >>> On Behalf Of kc9cdt@aol.com
> >>> Sent: Friday, February 27, 2009 4:13 PM
> >>> To: tentec@contesting.com
> >>> Subject: Re: [TenTec] 041 firmware rev
> >>>
> >>> Make sure stop on error is ON,
> >>> Lee
> >>>
> >>>
> >>>
> >>>
> >>>
> >>>
> >>>
> >>>
> >>>
> >>>
> >>> -----Original Message-----
> >>> From: Jim M. <jmiller1706@cfl.rr.com>
> >>> To: 'Discussion of Ten-Tec Equipment' <tentec@contesting.com>
> >>> Sent: Fri, 27 Feb 2009 4:04 pm
> >>> Subject: Re: [TenTec] 041 firmware rev
> >>>
> >>>
> >>>
> >>> Well not having a lot of luck here. Somehow crashed the O2 first time
> >>> trying with an old serial card in the PC, and it was very slow. Got a
> >>> USB
> >>> to serial converter and it flashed in about 5 mins this time but
nothing
> >>> in
> >>> the radio works, no knob, no buttons, and the display reads all zeros
> >>> frequency. Am trying the flash again. Stay tuned. So far I am
> >>> underwhelmed.
> >>>
> >>> -----Original Message-----
> >>> From: tentec-bounces@contesting.com
> >>> [mailto:tentec-bounces@contesting.com]
> >>> On Behalf Of Peter Frenning [OZ1PIF]
> >>> Sent: Friday, February 27, 2009 3:57 PM
> >>> To: Ron Castro; Discussion of Ten-Tec Equipment
> >>> Subject: Re: [TenTec] 041 firmware rev
> >>>
> >>> Ron Castro skrev:
> >>>> I have noticed that the levels between the AF and RF AGC's are quite
> >>>> different. The AF is very low compared to RF.
> >>>>
> >>>> Ron Castro
> >>>> Chief Technical Officer
> >>>> Results Radio, LLC
> >>>> N6IE
> >>>> www.N6IE.com
> >>>>
> >>> Same here, but doesn't seem to have detrimental effects other than you
> >>> have to twist up the AF
> encoder...
> >>>
> >>> --
> >>> Vy 73 de OZ1PIF/5Q2M, Peter
> >>>
> >>> ** CW: Who? Me? You must be joking!! **
> >>> email: peter(no-spam-filler)@frenning.dk
> >>> http://www.frenning.dk/oz1pif.htm
> >>> Ph. +45 4619 3239
> >>> Snailmail:
> >>> Peter Frenning
> >>> Ternevej 23
> >>> DK-4130 Viby Sj.
> >>> Denmark
> >>> ***********************************
> >>>
> >>>
> >>> _______________________________________________
> >>> TenTec mailing list
> >>> TenTec@contesting.com
> >>> http://lists.contesting.com/mailman/listinfo/tentec
> >>>
> >>> _______________________________________________
> >>> TenTec mailing list
> >>> TenTec@contesting.com
> >>> http://lists.contesting.com/mailman/listinfo/tentec
> >>>
> >>> _______________________________________________
> >>> TenTec mailing list
> >>> TenTec@contesting.com
> >>> http://lists.contesting.com/mailman/listinfo/tentec
> >>>
> >>> _______________________________________________
> >>> TenTec mailing list
> >>> TenTec@contesting.com
> >>> http://lists.contesting.com/mailman/listinfo/tentec
> >>>
> >>
> >>
> >> --
> >> I am using the free version of SPAMfighter.
> >> We are a community of 6 million users fighting spam.
> >> SPAMfighter has removed 302 of my spam emails to date.
> >> Get the free SPAMfighter here: http://www.spamfighter.com/len
> >>
> >> The Professional version does not have this message
> >>
> >>
> >> _______________________________________________
> >> TenTec mailing list
> >> TenTec@contesting.com
> >> http://lists.contesting.com/mailman/listinfo/tentec
> >>
> >> _______________________________________________
> >> TenTec mailing list
> >> TenTec@contesting.com
> >> http://lists.contesting.com/mailman/listinfo/tentec
> >>
> >
> >
> > --
> > I am using the free version of SPAMfighter.
> > We are a community of 6 million users fighting spam.
> > SPAMfighter has removed 1605 of my spam emails to date.
> > Get the free SPAMfighter here: http://www.spamfighter.com/len
> >
> > The Professional version does not have this message
> >
> >
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tent
> ec
> >
>
>
> --
> I am using the free version of SPAMfighter.
> We are a community of 6 million users fighting spam.
> SPAMfighter has removed 1605 of my spam emails to date.
> Get the free SPAMfighter here: http://www.spamfighter.com/len
>
> The Professional version does not have this message
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|