TenTec
[Top] [All Lists]

Re: [TenTec] 041 firmware rev

To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Subject: Re: [TenTec] 041 firmware rev
From: "Jim M." <jmiller1706@cfl.rr.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 27 Feb 2009 16:04:17 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Well not having a lot of luck here.  Somehow crashed the O2 first time
trying with an old serial card in the PC, and it was very slow.  Got a USB
to serial converter and it flashed in about 5 mins this time but nothing in
the radio works, no knob, no buttons, and the display reads all zeros
frequency.  Am trying the flash again.  Stay tuned.  So far I am
underwhelmed.

-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Peter Frenning [OZ1PIF]
Sent: Friday, February 27, 2009 3:57 PM
To: Ron Castro; Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] 041 firmware rev

Ron Castro skrev:
> I have noticed that the levels between the AF and RF AGC's are quite 
> different.  The AF is very low compared to RF.
>
>          Ron Castro
>  Chief Technical Officer
>     Results Radio, LLC
>                N6IE
>       www.N6IE.com
>   
Same here, but doesn't seem to have detrimental effects other than you 
have to twist up the AF encoder...

-- 
Vy 73 de OZ1PIF/5Q2M, Peter

** CW: Who? Me? You must be joking!! **
email: peter(no-spam-filler)@frenning.dk
http://www.frenning.dk/oz1pif.htm
Ph. +45 4619 3239
Snailmail:
Peter Frenning
Ternevej 23
DK-4130 Viby Sj.
Denmark
***********************************


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>