TenTec
[Top] [All Lists]

Re: [TenTec] 041 firmware rev

To: tentec@contesting.com
Subject: Re: [TenTec] 041 firmware rev
From: kc9cdt@aol.com
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 27 Feb 2009 16:06:39 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Yes,
I have noticed occationally only for a very short time the sweep goes red then 
back to normal. I have been running solid for 3 hours now.
It always recovers on it's own. By the way it's now new...before it did the 
same but did not have the 'NEW' red...it was just blank.
73,
Lee





-----Original Message-----
From: Dennis Duffin <duffind@verizon.net>
To: tentec@contesting.com
Sent: Fri, 27 Feb 2009 2:55 pm
Subject: Re: [TenTec] 041 firmware rev



I have noticed a couple of times after the rig has been on for some
time, the scope turns all red (signal indicators are still white) and
then lines start running from top to bottom.  First time, I did a master
reset and it went away.  This past time I simply turned off the sweep
and turned it back on and it was normal again.  Anyone experienced this
yet??
 
Dennis W5UV
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>