TenTec
[Top] [All Lists]

Re: [TenTec] 041 firmware rev

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] 041 firmware rev
From: John Sheeley <wb4qda@yahoo.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 27 Feb 2009 12:32:51 -0800 (PST)
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Dennis

Same here .I just turn the scope off and then back on. it corrects it.I sure am 
liking what I see so far in this update The AF agc setting just does away with 
most the noise on a very noisy 75 meter phone band today. Its like a whole new 
Radio .
More fun fron Tentec 
73
John wb4qda



----- Original Message ----
From: Dennis Duffin <duffind@verizon.net>
To: tentec@contesting.com
Sent: Friday, February 27, 2009 1:55:53 PM
Subject: Re: [TenTec] 041 firmware rev

I have noticed a couple of times after the rig has been on for some
time, the scope turns all red (signal indicators are still white) and
then lines start running from top to bottom.  First time, I did a master
reset and it went away.  This past time I simply turned off the sweep
and turned it back on and it was normal again.  Anyone experienced this
yet??

Dennis W5UV
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec



      
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>