TenTec
[Top] [All Lists]

Re: [TenTec] 2.041XL first audio crash

To: tentec@contesting.com
Subject: Re: [TenTec] 2.041XL first audio crash
From: kc9cdt@aol.com
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 01 Mar 2009 19:46:08 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Files don't have error detection code in them...the communications software 
protocols is where the error detection and correction (usually CRC/LRC or other 
check sums) is.

Using Microsoft IE I have never got a bad file that I know of.

73,
Lee, KC9CDT



-----Original Message-----
From: Jim M. <jmiller1706@cfl.rr.com>
To: 'Discussion of Ten-Tec Equipment' <tentec@contesting.com>
Sent: Sat, 28 Feb 2009 11:22 pm
Subject: Re: [TenTec] 2.041XL first audio crash



Be advised I had to reload the SW from the web site several times before I
ot it to work right.  Not sure, but I suspect I may have been getting some
ata errors during the transfer over the internet.  I don't know if the file
ad error detection coding in it or not.  This may be an issue.
-----Original Message-----
rom: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
n Behalf Of John
ent: Saturday, February 28, 2009 9:45 PM
o: Discussion of Ten-Tec Equipment
ubject: Re: [TenTec] 2.041XL first audio crash
I have tried to make my Orion II do what you are  describing  and I can not 
 I have no problem with either agc mode when the NR and Notch is on .  John
kb2huk
---- Original Message ----- 
rom: "Jim M." <jmiller1706@cfl.rr.com>
o: <sv8ing@yahoo.gr>; "'Discussion of Ten-Tec Equipment'" 
tentec@contesting.com>
ent: Saturday, February 28, 2009 9:15 PM
ubject: Re: [TenTec] 2.041XL first audio crash

I suspect there are some latent software coding "bugs" causing this, and
 also causing the "red flash" screen.  This is a beta, 
which means they
 should get these reports and eventually fix the bugs.  New software always
 has bugs.

 -----Original Message-----
 From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
 On Behalf Of Fotis SV8ING
 Sent: Saturday, February 28, 2009 3:07 PM
 To: Discussion of Ten-Tec Equipment
 Subject: [TenTec] 2.041XL first audio crash


 If I use NR and Notch together in the AF AGC mode,after a minute or so , I
 always get audio crash.I hear only ''white noise''.
 I change to RF AGC(which is fine) and then to AF AGC and the audio comes
 back.(or I switch the radio off and on )

 I tried it at least 10 times with the same results.

 73

 Fotis SV8ING

 GREECE







 ___________________________________________________________
 Χρησιμοποιείτε Yahoo!;
 Βαρεθήκατε τα ενοχλητικά μηνύματα (spam); Το Yahoo! Mail
 διαθέτει την καλύτερη δυνατή προστασία κατά των ενοχλητικών
 μηνυμάτων http://login.yahoo.com/config/mail?.intl=gr
 _______________________________________________
 TenTec mailing list
 TenTec@contesting.com
 http://lists.contesting.com/mailman/listinfo/tentec

 _____________________________________________
__
 TenTec mailing list
 TenTec@contesting.com
 http://lists.contesting.com/mailman/listinfo/tentec
 

- 
 am using the free version of SPAMfighter.
e are a community of 6 million users fighting spam.
PAMfighter has removed 1608 of my spam emails to date.
et the free SPAMfighter here: http://www.spamfighter.com/len
The Professional version does not have this message

_______________________________________________
enTec mailing list
enTec@contesting.com
ttp://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
enTec mailing list
enTec@contesting.com
ttp://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<Prev in Thread] Current Thread [Next in Thread>